Get the Best IPTV Service
Recent content by aimo | SatelliteGuys.US

Recent content by aimo

  1. A

    [help needed] dual LNB 1 receiver antenna messed up

    I sincerely appreciate everyone who has replied my post here. I have sucessfully and completely recovered all the channels I used to watch. Now, the 2 LBNs with1 receiver work perfectly. I wish someday I could help other people just like those who helped me here on the forum.I LOVE this forum so...
  2. A

    [help needed] dual LNB 1 receiver antenna messed up

    Thank you all for your kind advice. I have set my receiver as follows: Antenna: 1 (95w) Type Fix Satellite: Galaxcy 3C LNB Type: Normal LNB Freq 1: 10750 LNB Freq 2: 10750 0/12 Volt: None 22KHz Tone: 0kHz DisEqC: none C/Ku Band Control: None Antenna: 2 (97w) Type Fix Satellite: Telestar LNB...
  3. A

    [help needed] dual LNB 1 receiver antenna messed up

    In case the 0-22KHz switch is bad, can anyone suggest where I can buy a cheap replacement? Thanks a lot!
  4. A

    [help needed] dual LNB 1 receiver antenna messed up

    Update: after changing Freq 1 to 10750 MACTV dispears, so I changed it back to 5150, now MACTV is back as a result. Does it make sense? Thank you all for your kind replies. I will keep updating what I will have done.
  5. A

    [help needed] dual LNB 1 receiver antenna messed up

    I thank everyone for your replies. Here is what I copied from dual LNB, they are identical Dual Polarization Model PS41-1075 Noise 0.4dB Input 11.7-12.2GHz L.O. 10.750GHz, Any thoughts on what I should do? many thanks! My thoughts are the both LNBs capture 95w and 97w singals respectively and...
  6. A

    [help needed] dual LNB 1 receiver antenna messed up

    This is exactly what I have used in the past 4 years. Special 2-degree Monoblock LNB 1. Special 2-degree 0.4db Ku-band Monoblock LNB and the holder 2. SE830 digital receiver which is pre-programed 3. 0/22K Switch I have accidentally reset the receiver(SE830) to "factory default" which resulted...
  7. A

    [help needed] dual LNB 1 receiver antenna messed up

    Thank you so much for your reply. I am sorry that I am not a technical person. So, some descriptions may be inacurate and confusing. Please bear with me. My two LNBs are binded and hooked on one dish. The dish has no motor. It has a 0/22kHz 2X1 tone swtich. (the same as 0/22K 2X1 Tone Switch)...
  8. A

    [help needed] dual LNB 1 receiver antenna messed up

    I am trying to recover my 95W Galaxy and 97W Telestar, dual LBN with 1 receiver. Currently, I can only receiver 95w. I am not sure what is wrong with Antenna 2. Could anyone please review my following parameter settings? Antenna: 1 (95w) Type DisEqC: 1.2 Satellite: Galaxcy 3C LNB Type: Normal...
Top
Flash Sale Popup