It's happening on all the receivers (8 of them). I'm going to try and swap it out. So you said you can't use flex port 2? It won't work? Thanks for your help!

I'm picking up the 95 satellite. I took the LNB for the 101 out (not needed). My system has been working perfectly fine for the last 1.5 years. The mast is perfectly plumb and nothing can take it down. No tree blocking at all. Perfect line of site (it's on the very top of my roof.) I'm getting...

Also is it common that these switches fail after 1 1/2 years?

I did that. I hooked up the line that goes into the flex port and had a solid 100% on the birdog. I know it's not the coax line since I changed the coax cable. When I hooked the line back into the switch, I'll be able to watch the international channels again, but eventually it will freeze and...

Is it possible I could use the other port? (Flex Port 2) Would it work? Trying to eliminate all the possiblities

I have been losing signal from this satellite, My receiver will read (Acquiring Satellite Signal) when tuned to the international channels. Since DTV is charging to come out and fix it, I am attempting to fix it my self. I first checked to see if the Dish is in alignment which it was, since I...

Just installed my FTA MOTOR DISH!!!!!! and it works on the 22khz side!!! anyone have a satellite list for the Sonicview Elite 360? I am missing some satellites like 113 Satmex 6....

Hmmm...good to know...what about on the 22khz side? Will it still work?

Will a 22khz Encoda Switch work before the motor? Will I still be able to move the motor from the receiver? If not, how about I move the motor into the 0khz side? I don't want to run an extra coax cable into the house....I have too many cables :D Also, how about after the motor? Can I run...

I C&P from dishpointer.com :)

Thanks for the helps guys....I will try this later and let you know how it goes...

I just bought a HH90 motor with a Fortec 36" and an Invacom QPH-031....I was wondering what my true south satellite would be...... Latitude: 34.0989° Longitude: -118.1650° Motor Latitude: 34.1° Declination Angle: 5.5° Dish Elevation: 39° Elevation: 50.4° Azimuth (true): 180.0° Azimuth...

How long are your screws? I bought 8/32 - 2.5" Length screws......i couldn't get the 95 LNB to be tight...maybe its possible to use 2 of those Eagle Linear LNBS? since they are smaller in in thickness...

how did you get the 95 LNB to bolt down? I tried doing this earlier....and I would not get a signal unless it is bolted down tight....

DTV International Dish Is it possible to switch out the 101 Circular LNB to a Linear LNB to receive AMC 4 101 programming? Thanks