Yes, Fortec have a editor for the Dynamic, it's the same then the Mercury II, but you can't rename the sats. If you rename the sat with the editor it give you only a new sat. To Rename it with the remote. Menu>go to Utility, Ok on Edit Satellite, Ok on Edit Satellite again, now hit one of the...

Traxis 3500 very good scan and fast, I have had, Satwork (both), Pansat (2700, 3500, 5000) good scan but very slow, Manhattan Plaza ST350, Matrix, Coship, Coolsat slow and good scan, Fortec Ultra slow and bad scan, Europa 2000 and other, but the Traxis 3500 is the best. Saludos Hiebert

Good, cheap and fast blind scan, Traxis DBS3500. Saludos

The best and fasted blind scan, Traxis 3500

CNBC on INTELSAT 3R 43ºW 3845H 30800SR if you need more information on thes links, you will find all the Satellites available in Brazil. Brasilsat Digital Charts Saludos Hiebert

Anole Only the Pansat 3500 and 2700 can move the polarotor, or the picture on Pansat, it´s not true. Saludos Hiebert

Change the capacitors from the power supply and the Traxis will work again Saludos Hiebert

The fastes, the Traxis 3500 and very good to find new TP. I have had Fortec Ultra, Pansat 2500, 2700, 3500 and 5000, Sonicview, Coolsat and other and they are all very slow.

Hit menu, hit V+, press OK on Antenna Installation, now hit the green button, go to DisEqC and press V- and you will see MOTOR, by defauld it's OFF, now press OK and you can move the dish and store the Satellite. If you have level signal, that meant that LNBF is connected and is ok...

Traxis DBS 3500 is a good receiver, very fast blind search, very good signal meter and work great.

I use my Traxis DBS 4550 with two Dishes without problem, OK I don't use the same positions Nr for both dishes and don't use the SG2100. But I think if the switch change fast you will not have problem I use a DiSEqC switch from DMSi 4x1, on one port I have a V BOX II from Moteck and a 2m Solid...

On most of the Receiver, when the PC Editor work you can solve the problem. Saludos Hiebert

The 4500, 4550 and 3500 work without problem with DiSEqC 1.2 and the Moteck V-BOX II, use it with diferent dishes, 1,5m, 1,8m and 2,4m all solid dishes. Best picture have the 4500 and also the best remote. The 4550 have the same Freq. on the remote but it,s not so good, I must press it with...

I have the Traxis 3500 over 2 Month and use it with a SG2100 from DMSI without problem and use it also with the DP710, Actudor 24" from Moteck and a 2.4m Dish. I use a Manual switch to change from C to KU, I try it also with a DiSEqC, but with problem, the Sat on DiSEqC 1 not problem but it will...

Iceberg Please read my post again, I had not write Diseqc 1.0, 1.1 or 2.0, I write Diseqc 1.2 If you can use a Motor with Diseqc 1.2, then you can use also the switch. I post the links where you can read it also. Saludos Hiebert