I would like to receive the channel sportsmax but i realize i would have to have a C-band dish. i am thinking about trying a 1.2m offset dish or a 160cm dish from digiwave. Howevere i am unsure if this channel is FTA or encrypted. I checked lyngsat and noticed that it is listed under two...

The motor is under 1 year old. Its about 6 months since I first installed it. It is so much easier to install than my other motor which does not have the USALS feature.

Up and Running Again I removed the motor and popped it open. The motor was stuck at the eastern end of travel and was unable to move. However while fooling around, I got it to move but it continued to the western end of travel and remained there. I could not get it to move. I emailed...

I have a motorized system driven by a coolsat 5000. My antenna is 90cm and is mounted on a stab HH90 motor. It has been working fine until yesteday morning. I was watching GolTv on 110W then I tried to switch to 103W but the motor did not move. I then tried PAS9 at 58W and same result. I used...

I looked at pictures on the back of a pansat and i noticed that it has a pair of 5V connections. i assume that this is the polorotor connection you are referring to. The coolsat does not have this connection. Can a regular feedhorn like Item #3570011 at skyvision.com work?

I have a motorized FTA setup with two coolsats (4000 and 5000). I would like to pick up the channel Sportmax on Intelsat 707 at 53W. I am planning to get a 150cm PrimeFocus dish with a C-band LNB but I am not sure how this would work on the coolsat 5000 when changing polarity. I have been...

misunderstanding. Sorry to confuse you. I did not get any two satellites at the same time but I'll try some of the combinations you mentioned. Thanks

I have a KU and DSS band LNBs on a 75cm motorized dish (DISEQc 1.2). The KU is in the centre and the DSS is offset to the left ( standing behind the dish ). My true south satellite is AMC5. I noticed that I am able to pick up AMC5, Nimiq2 and Echostar6/8 without adjusting the elevation of the...

Big Task Thanks. This setup looks like it is going to be a huge task. You guys must be really patient

Brackets i got them at AA electronics. A small electronics store in Mississauga, Ontario

Thanks Thanks for the advice I'll try it over the week end. I started to install the dish but the space is too small so I'll have to find a different location. see below

I am new to his FTA stuff. I have a coolsat 4000 pro receiver, 30 inch dish, a digiwave DGHH-990 motor, KU band,DSS LNBs and, 4x1 DiseqC switch. I am confused about two things. 1. How to wire the switch to the motor and two LNBs. The switch will have two wires coming from it(LNB1, LNB2) but...