RC64 remote

[lenjack]

Just obtained an additiobal remote for my H20. It's an RC64. the original was an RC32. What is the difference? I cannot find any.

 

[Brewer4]

I dont think there is any. I have an RC34 and it is the same except the buttons are bigger and its a bit flatter then the RC24.

 

[boba]

The RC64 is the newest and has more stored codes for those odd brands of TV and receivers.

 

[Tom Gee]

Some of the code between the two are different! Example: Volume and mute on my Harmon Kardon Receiver work on the RC34 but not the RC64.

 

[Tom Gee]

Remote Code for Harmon Kardon AVR7300

Can anyone help with a remote code for AVR7300. Key code 31304 and 31306 will power unit off, but volume alway return as a un programmed key. Remote RC34 work okay. Remote RC64 is the problem child.

Thanks!

 

[Edmund]

the volume keys NEVER work initially with ANY audio code, not until you do the following. First there has to be a tv code programmed to the tv device or the volume keys won't work. then:

1. av1 or av2
2. press and hold MUTE & SELECT for two blinks
3. enter 9 9 3
4. press SELECT

 

[stevesmall]

Just obtained an additiobal remote for my H20. It's an RC64. the original was an RC32. What is the difference? I cannot find any.

Hello
the rc64 is backlit which makes it much easier to see in a dark room and also comes with a book with additional codes for more tcs vcrs etc that the rc 32 did not operate. it works very well btw

 

[Edmund]

Only the rc64rb is backlit, the rc64 & rc64r aren't.

 

[Tom Gee]

Finally fix the problem. There is probably a software bug with the firmware. Unless there is a program under TV, volume can not be map properly. After a bogus TV selection, I was able to program the volume to work with my Harmon Kardon receiver as the screen entries descript.

 

[Tom Gee]

the volume keys NEVER work initially with ANY audio code, not until you do the following. First there has to be a tv code programmed to the tv device or the volume keys won't work. then:

1. av1 or av2
2. press and hold MUTE & SELECT for two blinks
3. enter 9 9 3
4. press SELECT

Thanks! Did not see this until, I struggle thru the setup.