Anybody got the instructions on setting the East - West limit switches for the 24" Venture "Maxi" actuator?
I'm installing an old one of these, and I don't think it's going far enough EAST before limiting out. It doesn't go very far past dead South before shutting off. Perhaps I only need to move the clamp on the back, to readjust how far East it goes? I just got this actuator with a larger dish, and I just installed it as it was set from whatever dish it used to be on. I did not move the clamp on the motor. Didn't even think of it until I started writing this post...
I'm installing an old one of these, and I don't think it's going far enough EAST before limiting out. It doesn't go very far past dead South before shutting off. Perhaps I only need to move the clamp on the back, to readjust how far East it goes? I just got this actuator with a larger dish, and I just installed it as it was set from whatever dish it used to be on. I did not move the clamp on the motor. Didn't even think of it until I started writing this post...
