Switch Question

[SarKen]

I have a super dish connected to 119, 110 and 121 with a second dish connected to 61.5. 121 was used for locals, now my locals are only on 61.5. The channels are still on 121 with a message stating that my locals have moved. I could not get the system to pick 61.5 first then 121.

So what I did was remove the 121 feed from my switch from the forth input. Is this ok to do?

Thanks,
Ken

 

[garys]

Not sure how the proriority works on 121, but if there is nothing on 121 you want just disconnect that line and run a check switch test.

 

[SarKen]

Not sure how the proriority works on 121, but if there is nothing on 121 you want just disconnect that line and run a check switch test.

That is what I did. I just want to make sure that it will not hurt anything.

 

[vegassatellite]

You're good. Just make sure to do a checkswitch afterwards to clear out guide data for 121 or you will have searching for satellite messages on some channels.

 

[SarKen]

You're good. Just make sure to do a checkswitch afterwards to clear out guide data for 121 or you will have searching for satellite messages on some channels.

Thanks for the info!

Ken