Is it possible to use the output feed from the DP34 switch to connect to the TwinHan 102g card?
I just got it in yesterday, had it working for about 5 minutes shut down the software and back to nothingness.
I installed their drivers several time but no dice. Through their software I get around 60-70% signal and about 75-85% quality, but it never says it can find a channel.
Needless to say I'm fairly new to this. Read tons, but this is my first practical experience. Figured I'd start cheep w/ a PC card and my E* dishes that I know I get signal on.
I did try connecting it to one of the 4 outputs on the DP34 and that was far less effective. Both my 622 boxes started searching for signal.
I just got it in yesterday, had it working for about 5 minutes shut down the software and back to nothingness.
I installed their drivers several time but no dice. Through their software I get around 60-70% signal and about 75-85% quality, but it never says it can find a channel.
Needless to say I'm fairly new to this. Read tons, but this is my first practical experience. Figured I'd start cheep w/ a PC card and my E* dishes that I know I get signal on.
I did try connecting it to one of the 4 outputs on the DP34 and that was far less effective. Both my 622 boxes started searching for signal.
